https://www.nopistons.com/forums/pub...1047683473.gif i have for sale a rebuilt stage 2 port/polish has 1,100 miles
parting out due to rear end..this engine was built with all quality parts with jdm low mileage rotor housings...this engine comes as a long block and is fully powder coated blue/silver it included the fallowing rotary aviation apex seals 93+ solid corner seals 93+ corner seal springs atkins rebuild kit s5 jdm rotor housings stage 2 port/polish from dave at rotary heads .com ported polished throttle body also by dave at rotaryheads every seal replaced all new gaskets all emissions removed andonized blue block off plates rebuilt 550cc primary's greddy 720cc secondary's all intake manifolds dual belt alt pulley s5 turbo f1 racing clutch(1,100 miles also) turbo tranny if needed.. 3"turbo inlet duct wiring harness and ecu (rtek 1.7 at an extra cost) all of the above for $2,500 this is damn near a racing engine drop in before rebuild and port i ran 14.02 at 98...engine was also broken in properly= no boost and rpm under 5k.. |
|
>bump
|
bump
|
anyone,,,,,???
|
i might have a guy interested in this motor. hes looking for a t2 long block to put in a 1st gen rex. how much HP is this motor putting down?
|
All times are GMT -5. The time now is 12:46 AM. |
© 2024 MH Sub I, LLC dba Internet Brands