I cannot remember all of the details about this engine right now, so I will get everything straight in the morning.



It was built by some company in Puerto Rico, company name stamped on the housings, just cant remember. Bought this thing about 6 months ago and eneded having to rebuild it because they machined the 3mm apex grooves a little too much, so it had no compression.



It has RA apex 2mm seals, solid corner seals with 3rd gen springs, new side seals, new springs. Also has a bucnh of other stuff done to it like hardened stationary gears, 3 window main bearings, polished e shaft, 80 psi regulator, thermo pellet, and probally alot of other stuff that has slipped my mind.



I am selling the engine for $1500 plus shipping.



I will post some pics in the moring, but if you want to see one right now, look in the garage and look for me, there is a pic there.



I am selling this engine because I have started school again and I do not have time to finish this project. If any one is looking for an 87 T2 that is basically race ready, I have on of those also.

Here are some pics. I also have a T2 5 speed and an ACT 6 puck clutch. The front cover is also powdercoated chrome. I also have the gilmer belt drive available. The stamp on the rotor housing says "mec gueo racing"

gilmer belt drive how much ? I have a 4 port 13b bridgeport. Thanks for your time DAve...

$175 shipped. It is brand new, never used. Just been sitting there.



Also, I have a pair of rotors that have been milled to except larger side seals and larger apex seals. They are the ones that were milled a little too large for the 3mm, so you may have to go to brittish seals, like the 4.3mm or more. I am selling these rotor for $100 plus shipping.

do you still have the belt drive if you do ill take it!!!