NoPistons -Mazda Rx7 & Rx8 Rotary Forum - F/s

Item for sale on Ebay:

http://cgi.ebay.com/ebaymotors/ws/eBayISAP...item=7973061018

No reserve

This is the wiring harness off my 91 TII (91,000 miles). I am going with a Haltech E6K with the flying lead harness so this stock harness is not needed.

The harness came out of a running car and the car ran great! Last pass down the 1/4 mile was 13.72 @ 103.

The harness is complete as far as I can tell. And it is still pliable and not crispy.

There are some things with three parts of the harness. Two connectors have been removed because they melted. Gotta love rotary heat. One connector is one that went to the ACV (Air Control Valve). This can be spliced into the ACV so that is not a problem. There other connector I am not sure where it went. However, it WAS emissions related. My car ran fine with no check engine lights and I was not using the emissions system.

Also, the O2 sensor wire in the harness was not right. So, I ran a new wire from the female connector when it goes into the ECU and ran that straight to the O2 sensor. This worked fine and I got about 22MPG on the high way so I know the O2 sensor was doing it's job.

Other than the harness is complete and has the plugs for the cruise control and the wiper motor. The harness had been spliced for a FCD and a SAFC. However, I returned the harness to stock and soldered all the connections.

Pictures:

The Harness:

http://img.villagephotos.com/p/2005-...60(Medium).JPG

Close up of part number still on harness:

http://img.villagephotos.com/p/2005-...66(Medium).JPG

I extended the fuel pump jumper connector since it is SO hard to get to in the engine bay.

[IMG]

O2 Sensor wire extension off of ECU plug:

http://img.villagephotos.com/p/2005-...61(Medium).JPG

First missing connector:

http://img.villagephotos.com/p/2005-...64(Medium).JPG

Second missing connector:

http://img.villagephotos.com/p/2005-...65(Medium).JPG

I added a second ground wire for the boost sensor. This is a good thing to have since the grounds on the FC are not the best designed. Bolt this to bare metal. I used the bolt that mounts the boost sensor to the right strut tower.

http://img.villagephotos.com/p/2005-...62(Medium).JPG

Being used this harness is sold as is. I am not responsible for what you do with it and you need to make sure this is what you need for you car. I will try to help the best that I can.

As far as payment goes I need the money so that I can ship it no later than Monday May 9th. If the I don't have it by then there will be a 10 day delay on shipping (Vacation) So, if you get me the money fast I will ship fast. This will be shipped either USPS or Fedex. It really depends on when I get the money. Good luck! And I will try to answer any questions you have.

Good luck!

James