Newbie with a crazy thought
 

https://cimg0.ibsrv.net/gimg/www.nop...333cb4a3a.jpeg
Good morning and thanks for the opportunity to join the group. I have been working at an engine builder shop on and of for 30 years and have done some interesting things to engines. But I'm a newbie with theses rotorys. My though here is to build a very lightweight higher horsepower race motor basically to put on a four wheeler drag chassis. So don't beat me up my mind gets a little out there. I want to take a single rotor and housing peripheral ported and basically eliminate everything else by using steel lined heat sink finned aluminum plates for end housings high speed sealed bearings and possibly an external oiling for what is needed. We run 260 300 500 and 1/8 mile. My thoughts are minimal water if any with alky should keep it cool for the 20 or 30 seconds of run time and hopefully 3 to 6 seconds of go time again my mind wonders off some but I see this as a doable engine with a turbo I would like to see somewhere in the 350 HP range. I have no problem piping coolant through the housing if necessary also ...possibly adding a little 2cyle oil to keep the heat down. But know I'm just rambling lol. Well let the stomping begin ...and thanks in advance for the great knowledge that can be found.