A little about the bearing tool, the tool used for pressing in the bearings was a custom one I built on the lathe far bettor engineered then the factory one.

Couple pics of when I was turning it down on the lathe, Attachment 19779

Attachment 19780

Now about the tool, here is the tool stacked

Attachment 19781

All of the pieces are machine to slip together and utilize for storing and a guiding tool together for the press. There are also several ways to use the tool.

The inner cylinder here is used for pressing the stationary gears in and out. One side of the cylinder pushes the bearing out, flip the item over and it seats the bearing. The out portion is shown here

Attachment 19782

This side is 2 steeped as the inner step seats inside of the bearing to prevent the tool from walking and even the pressure across the bearing. The second step catches the gear at the exact moment the bearing is freed and falls thru. I also use this side to start the bearing in. Now on the other side we see the seat portion

Attachment 19783

This side is 2 stepped as well if you look closely there is a half thousandth machine step in the middle then a second machined grove. The second machined groove is designed to clear the bevel in the front stationary gear. The inner groove is designed to perfectly seat the bearing flush into the gear. Here is a far shot of the inner sleeve and bearing tool.

Attachment 19784

This portion is the rotor bearing extractor tool

Attachment 19772

The inner portion is machine grooved to seat inside the bearing to prevent wobbling while the outside is machined to slide perfectly thru the rotor. Flip the tool up to look at it as it would be seated on the bearing

Attachment 19773

You see another machined grove this grove seats the guide collar or slip sleeve. When the collar is in place the stationary gear puller is machined in the middle to perfectly slip inside to give the press a perfect contacting surface of force applied to your work, the assembled tool shown here.

Attachment 19774

This tool is used to seating the rotor bearing

Attachment 19775

I use the extractor tool to start the bearing after that this tool is used to ensure a perfect seat.

Attachment 19775

This is machined the same way as the stationary gear seat tool and the rotor bearing extractor tool seats upside down into the seat tool like this

Attachment 19777

The tool finish assembly looks like this

Attachment 19778

And there you have it an IBP bearing tool.

nice, i miss`workin in the machine shops

nice! now make me one! https://www.nopistons.com/forums/pub...IR#>/bigok.gif

Nifty. Is it steel?



B

Aluminum