hey guys this was my first time porting, i used RB porting templates, which i found out arent that big. i practiced on some junk endplates adn housing i had. i need to know how i did, and what i did wrong and such. can i go bigger?



http://www.imagestation.com/picture/...b/f81c26a8.jpg



http://www.imagestation.com/picture/...3/f81c26b4.jpg



http://www.imagestation.com/picture/...8/f81c248e.jpg



if pics dont show up try right click show picture, they are hosted on imagestation.

you need to not port red x's in your ports :P

hmmm red x's make a lot of power

ok sorry about that guys, i forgto how much imagestation sucks,

http://www.teamfc3s.org/forum/attachment.p...=&postid=337785



http://www.teamfc3s.org/forum/attachment.p...=&postid=337786



http://www.teamfc3s.org/forum/attachment.p...=&postid=337787

i redid the exhaust port today, i think i got it pretty good. i try to fix the intake port btu i just messed it up more with the dremel gettting caught in spots creating a bumpy edge. at least it was just a practice one. im gonna start the real ones tommorow.



pic of new exhaust port



http://www.teamfc3s.org/forum/attachment.p...=&postid=338910

On the dremel thing, if you use a flex shaft with a good carbide bit, you can run it on high and lightly go over the high spots. This will create a nce even cut, its when you start to put a lot of pressur ein the cuts that they dig in.