hi guys i have a ? i did a bridge port on my engine.but i was told that ill need to cut a slot on my rotor housing but my ? is what will hold the small coner os the apex seal.my apex seal is a 2pc not a solid one.my bridge port cut can out ok. need hlp on the rotor housing please that's guy's. https://www.nopistons.com/forums/pub...1047683561.gif
|
seriously
|
Originally Posted by pedro a' post='922960' date='Jun 13 2009, 03:35 PM
hi guys i have a ? i did a bridge port on my engine.but i was told that ill need to cut a slot on my rotor housing but my ? is what will hold the small coner os the apex seal.my apex seal is a 2pc not a solid one.my bridge port cut can out ok. need hlp on the rotor housing please that's guy's. https://www.nopistons.com/forums/pub...1047683561.gif
A full "J" bridge port with stock apex seals presnts some insurmountable problems. If you cut open the rotor housing to match the port in the iron the small corner piece will fall out of the slot. If you have not ported the center iron yet, you could do a conventional bridge port and install the apex seals with the corner piece against the center iron. Or, you could leave the center iron stock, or, you could street port the center iron. With no rotor housing mods against the center iron there is no problem. If you have "J" ported all of the irons, then you need a solid apex seal of some kind. Steel, ceramic, or carbon. Or another center iron. Lynn E. Hanover |
All times are GMT -5. The time now is 04:10 AM. |
© 2024 MH Sub I, LLC dba Internet Brands