i saw a picture that in the area where you do the bridge porting instead of opening that area there were holes drilled does anyone have seen it,those plates have about 5 holes drilled right behinde the port.does this work. https://www.nopistons.com/forums/pub..._DIR#>/dry.png

Never though of it https://www.nopistons.com/forums/pub...1047683561.gif



Would prolly work but not as efficient as a real bridgeport. You should try it and tell us what happens. Call it a holeport

No point whatsoever in doing that, except to save work - you'd get just the same overlap as a real bridgeport, and the extra material in the way would just restrict the flow - so you'd get an idle that would be just as bad (or good depending how you look at it) but not as good high-rpm power.



J

yeah, id go with just a bridge. wouldnt **** around like that unless i have the money to