4 Rotor Build
#54
Re: 4 Rotor Build
Hi
I just came across this post and I felt the need to register just so I can tell you great I think it is!
I am truly in awe of the level of detail in this project and I especially think the exhaust is a work of art!
I know it's an old post but I hope this message gets to you
Matt
I just came across this post and I felt the need to register just so I can tell you great I think it is!
I am truly in awe of the level of detail in this project and I especially think the exhaust is a work of art!
I know it's an old post but I hope this message gets to you
Matt
#56
Re: 4 Rotor Build
Roughturning the material, I started with a 125 pounds weighing slob of material. About 75 - 80% of the material ends up in the bin.
After an hour of turning
I flipped the shaft around and started on the other side, after machining:
This is where I am at the moment.
Let me know if there are any questions
After an hour of turning
I flipped the shaft around and started on the other side, after machining:
This is where I am at the moment.
Let me know if there are any questions
Thread
Thread Starter
Forum
Replies
Last Post
ReactionEffect
Rotary Engine Building, Porting & Swaps
10
09-28-2005 03:26 PM
BDC
Rotary Engine Building, Porting & Swaps
41
01-25-2005 12:27 AM
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests)