Hello Guy's new to the forum , I have been searching the forum for few days and I have to say that it is a honor to be part of this forum and the valiable information you guy's have on herem. I am currently getting a S5 engine with a t80 turbo on methanol built for all out dragracing by JR Fab AKA Just Racing Frabrication in Port ST Lucie Fl and we are undecided on the exhaust port . I am asking for everyones opinion we went with the 3rd gen rotor housing , we are not sure if to go with early opening or a bit of both early opening a bit on late closing . what you guy's think



Best Regards

Gilbert

where are you JudgeIto ? LOL need opinion . Post up pic P.S https://www.nopistons.com/forums/pub...O_DIR#>/v2.gif

Very cool, Gilbert! My advice is to focus more porting upwards (closing edge) rather than opening edge. The earlier the exhaust port opens, the lesser amount of torque per stroke will be made due to the stroke being shorter. Honestly, in my experience, there's not a real need to make the exhaust port the size of a lemon. Here's how I it:



http://bdc.cyberosity.com/v/EnginePo...xhaustPorting/



B

BDC you preffer you exhaust port to be late closing by raising the port upwards and shaping the lower part of t port with the sleeve . thanks for your opinion BDC . alright where is the rest of you guy's opinion looking for more ops !

yeah i like to match the opening of the port to the sleeve, and keeping the factory bevel, or just plain rounding it off.



i dont like to close the port too much later, as i've gotta pass smog

well I dont have smog issues here and this is going to be strictly for racing , is the later closing best for my application ?

porting 2mm towards your exhaust opening will help to spool that big turbo you have, and will not sacrifice your exhaust stroke. 2mm is fairly nothing and will not effect your exhaust stroke to much, but the increase in exhaust flow is noticeable and very helpful. Porting towards the exhaust closing increases overlap, and that to me is always y NO-NO...

I have posted pictures of how to port away the factory 2mm bevel towards the exhaust closing, and then port the 2mm bevel back into the closing edge. this way you have increased port timing but keeped overlap down to a minimun.

Awww Juan, overlap isn't a no-no. Try telling that to the two-stroke racing community. https://www.nopistons.com/forums/pub...#>/biggrin.gif



B

I agree with you on the overlap , thank you for sharing this valuable info with us . I tried serching this pics you mention but did not come across them , do you remeber where you post them ?



Thanks Gilbert

Brian you know where you'll notice how bad overlap on a rotary is. On N/A motors. I dislike and it's proven no gains at low rpm torque and power. totally a subject of topic in itself. maybe one day we could all shine in on our experiences on this subjet in a different thread, made to talk about this issue.. be good Brotha