Hello,



I'm new on your forum.



I'm French and I will buy a SA22 79'.



The motor is died.



And I would like make a 3rotor N/A and swap into SA22.





But I have some questions on this subject.





the best is to leave of which base ?





Transform a 13b to 3rotor ? (and for the camshaft ?)



or to start from a base 20b ?



I would like that it is in carb





Thank you https://www.nopistons.com/forums/pub...DIR#>/wink.png



Sorry for my English

I have to seek and it would be complicated too much and expensive for a 3rotor https://www.nopistons.com/forums/pub...>/rolleyes.gif





a 13B N/A is interressant level preparation ?

Me no thinkith there be a camshaft on rotary engine https://www.nopistons.com/forums/pub...DIR#>/wink.png



Go 13B turbo https://www.nopistons.com/forums/pub...IR#>/bigok.gif

yes I know but I do not know the English name https://www.nopistons.com/forums/pub...R#>/unsure.png

Crankshaft.



Mark

ok



Thank you. https://www.nopistons.com/forums/pub...IR#>/smile.png

Correct term is Eccentric Shaft for a Rotary. Bon jour, welcome aboard

CAMSHAFT https://www.nopistons.com/forums/pub...1047683785.gif https://www.nopistons.com/forums/pub...1047683785.gif https://www.nopistons.com/forums/pub...1047683785.gif

So the motor is died? what color https://www.nopistons.com/forums/pub...1047683785.gif and i think u can use the same 13b or 12b camshaft https://www.nopistons.com/forums/pub...1047683785.gif https://www.nopistons.com/forums/pub...1047683785.gif https://www.nopistons.com/forums/pub...1047683785.gif just make sure to get a" VALVE" job b'c the RODS on a 3 rotor spin faster and you could brake a "PUSHROD" https://www.nopistons.com/forums/pub...1047683785.gif https://www.nopistons.com/forums/pub...1047683785.gif https://www.nopistons.com/forums/pub...1047683785.gif

dude, shut the **** up. The guy said that he was French and apologised for his english.



If your going to be an ass, go to rx7club.com