For sale: 1983 Mazda Rx7 GSL







Series 5 13BTurbo.



It was rebuilt 20k miles ago by me with a mild streetport on the intake and a nice big streetport on the exhaust. This car was fast as fawk when it runs good. I’d honestly say it was a low to mid 13 second car. I could and have easily walked on STi’s, Shinka Rx-8’s, and a few 5.0’s. I’m selling it because I think it’s blown again. It still starts and runs, but it runs like ****. I think it’s a stuck side seal or a cracked corner seal. Or it could be something as simple as a bad intake manifold gasket. I’m just too tired of spending $400 a week on this car.







Mods:



Streetported S513BT



S5 ported waste gate turbo



Hockey puck engine mounts



Turbosmart MBC



3” Turbo back exhaust consisting of a 3”Racing beat down pipe 3”dynomax bullet silencer and a 3” Magnaflow muffler



Turbo prepped Weber 45DCOE



Rtoary Shack carbhat



Greddy Type-s BOV



Modded Pineapple alt relocation bracket



FD alt with DBL sheeve pulley



MSD fuel pump. With relay



Mallory 4309 FPR



3/8” hard fuel return line



MOP block off plate



Racing Beat upper intake manifold



K&N air filter



MSD Direct fire ignition with a DIS coil



MSD Wires



B9ES plugs all around



FAL e-fan with manual switch and an auto temp switch that comes on at 183*



Optima Yellow top relocated to behind passenger seat



Eibach Prokit springs



Tokico HP (Blues)



Enkie 92 Series 15x7+15 offset 4x110mm. 205/50 Kumho 711 in front unknown 225/50 in rear



Personal Steering wheel with removable hub, 2” Sparco extension, and a Momo hub.



Momo Corse seat



Momo Corse peddals



Autometer water temp, oil pressure, narrow band air fuel gauge, shift light and pill kit 7000-7800



DIY short shifter and Razo shift knob



Spearco Boost gauge



Back half of interior stripped



Weighed in at 2355lbs.







Also included in sale is a set of 24.5x9x13 Mickey Thompson drag slicks mounted on 13x8 custom rims 4x110mm, IMSA GTU option front end. Isuzu NPR short intercooler, rx7 TMIC, S3 ported lower intake manifold, stock s4 lower intake manifold, Heim jointed FB rear axle lower links, and what ever Mazda parts I have sitting here.







I’m looking to get $2500 for it. There is well over $6000 invested into this car. I need something reliable. I am willing to entertain trades. The car still starts and drives but it drives like ****. I WILL NOT PART OUT I DO NOT HAVE THE RESOURCES TO DO IT!!!







http://s114.photobucket.com/albums/n273/Hy...B%20For%20Sale/



http://seattle.craigslist.org/see/car/273419814.html

So sorry, you put your heart into that car.

JEB