NoPistons -Mazda Rx7 & Rx8 Rotary Forum

puigmiquel

Junior Member

Last Activity: Jun 19, 2013 06:44 AM

About Me

  • About puigmiquel
    Your First Name
    Jaume
    Location
    Catalunya
    Occupation
    Mechanical engineer
    Year Of Your Rotary
    2007
    Pick your Model
    n/a
    Power Adder
    n/a

Statistics

Total Posts
Albums
Visitor Messages
General Information
  • Last Activity: Jun 19, 2013 06:44 AM
  • Join Date: Sep 5, 2011
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. Lynn E. Hanover
    Apr 23, 2012 03:27 PM - permalink
    In order to remove the center iron you must remove the front pulley and allow the shaft to lift up with the center iron about 2 inches and tip the iron to one side a bit. Turn the shaft so the lobe is on one side of the engine and tip the iron the other way and lift up.
    Lynn E. Hanover
  2. thatpoorguy
    Mar 22, 2012 06:00 PM - permalink
    every build I've ever seen done is started by removing from the rear first and removing a housing or plate at a time. My build was actually done by a shop here in indiana so I can't really give a good step by step, but there are many great threads on this in the rotary build/porting section in this forum

All times are GMT -5. The time now is 06:07 AM.