NoPistons -Mazda Rx7 & Rx8 Rotary Forum

I have lurked around the rotary world for a few years, I just got 90 GTU, body is little rough, it has steet ported 13BT with S4 rotors, and bunch of parts on order for it.

I have debated finding a cleaner chassis but I feel good about saving this one. Though most of the body work will come later this year after its runing and performing the way I want it to.

Basically the car had the ported turbo motor on a NA driveline when I bought it, previous owner had to be one of the worse mechanics I have very seen. I have been spending the last few weeks finding and fixing his screw ups and getting everything the way I want it. I.E. No PS and AC

Right now, the parts I have sitting waiting to be installed or on back order https://www.nopistons.com/forums/pub...IR#>/smile.png

Turbonetics T72 BB Q-Trim

TiAL 46mm WG

Turbonectics Godzilla BOV

Spearco intercooler with a 13X24X3.5 core (I will have to take the plasma cutter to car to make it fit)

FD UIM (which is going to be a PITA to fit)

Koyo radiator

Black Magic Electric fan

ACT Street Light flywheel (cryo treated)

ACT Extreme Pressure Plate and 6 puck clutch (cryo treated)

S5 Turbo tranny

Mazdaspeed short shifter

Mazdaspeed steering wheel

GReddy PRofec B

Electromotive TEC3

2 1000cc injectors

2 1600cc injectors

Walbro 255 (till I get the cash for a sumped fuel system with -10 line and aeromotive pump)

DEFI Boost and EGT gauges

R-Magic Gauge Pod

The Driveshaft Shop Stage 5 axles

Corksport front and rear STB

Cusco lower control arm

Prothane Poly bushings

FD front cover, alternator, and water pump

TEIN Flex system coil overs with EDFC

Solid motor, transmission, and front diff mounts.

Turbo II brakes with Hawk pads and Brembo replacement rotors (brakes and rotors cryo treated)

I think this is most of it, at least the big stuff. I have about 50% of it ready to go it, rest is ether still on order or on back order.

I still need to locate a S4 rearend setup, order parts to rebuild the the diff that comes with it, a driveshaft, and some junk axles so I can build up my driveshaft shop axles (spend 600 bucks on upgraded axles and their not even built up. https://www.nopistons.com/forums/pub...>/rolleyes.gif

Oh yeah, I need some time, so if anyone got any laying around I need it. https://www.nopistons.com/forums/pub...#>/biggrin.png