i just joined the forum. I purchased a 1987 Turbo II with no motor in car but it came with a JDM replacement motor and trans.



I didn't remove the motor myself so i was looking for any helpful hints/tricks that i could use during the install.



The new engine needs all the intake electrical harness and vacuum hose assembly to be transfered from the old engine. I have new motor mounts that came with it.



Look forward to hearing from you guys, and any help you can provide is appreciated.



Joe

just joined my sefl im from nyc i have an fb 84gsl-turbo carberated.ive been into mazdas since 89.. welcome to rx7 heaven.. ps dont give up becouse alot of people do.. peace....

welcome to nopistons! its a great site and the people here are great at helping solve problems.

roanoke,va i used to drive my 7 out there every other weekend all the way from nyc i used to go to rocky mount ,va

cool. i went to high school in rocky mount.

Welcome to no pistons.

wecome https://www.nopistons.com/forums/pub...1047683329.gif https://www.nopistons.com/forums/pub...IR#>/bigok.gif

welcome and enjoy the site...more importantly, enjoy your FC https://www.nopistons.com/forums/pub...IR#>/smile.png

Thanks guys.... any suggestions performing the JDM swap? the car is 1987 t2, the JDM vin on the motor is fc3s-237129

welcome!