| Rob x-7 |
05-07-2002 07:22 PM |
Clean the OUTSIDE of the window with some glass cleaner, or even some rubbing alcohol. Center the decal which is pretty much between the O&N, make a mark on the center of the OUTSIDE window if youre not sure of yourself putting it center, you can use electrical tape as a guide. Peel the decal away from the backing being sure that it all comes away , remember they go on the outside, so the heavier solid white paper will come away, and the decal will be on the waxed looking paper, grabbing both ends with your fingers, pull it tight so that it doesnt go on wrinkled, and all at once apply it to the window starting at one end, or all at once if your comfy with your skills. Using your hand, rub the waxed paper firm to get out any bubbles ( which hopefully you pulled it tight enough so there arent any ) and to insure adhesion. Then slowly peel away the paper starting from a corner making sure that the decal remains on the window, remember, this is a die-cut decal, so it will be all seperate, not one big sticker. I wouldnt recommend doing it when its freezing out, but it will stick even in the cold to a clean window. Sorry about the un-even cut along the bottom, but I got these on a huge sheet and the computer spits them out as tight as possible to save material, and the lower case "p" and the upper case "t" was AWFULLY tight against each other! And cut them out with a 10" scissor. Here is the old pic, I got to take a new one. Whew that was alot https://www.nopistons.com/forums/pub...DIR#>/Wow1.gif |
