NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   Insert BS here (https://www.nopistons.com/insert-bs-here-12/)
-   -   Acceleration/ Red Meat/ (https://www.nopistons.com/insert-bs-here-12/acceleration-red-meat-31749/)

howracer 01-12-2004 08:32 PM

while not quite on the rotary subject there is some real red meat in here... and when you consider that Carlos Montano's new 3 rotor had a shakedown run at 7.96 seconds and the front wheels didn't touch down for the first 1/8th mile maybe it is closer to our rotaries than at first glance... make sure you don't miss the end of this piece.

One Top Fuel dragster 500 cubic inch Hemi engine makes more horsepower than the first 4 rows at the Daytona 500. Under full throttle, a dragster engine consumes 1-1/2 gallons of nitromethane per second; a fully loaded 747 consumes jet fuel at the same rate.

A stock Dodge Hemi V8 engine cannot produce enough power to drive the dragster supercharger.

With 3000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into a near-solid form before ignition. Cylinders run on the verge of hydraulic lock at full throttle.

the combustion chamber flame front temperature measures 7050 degrees F. Nitromethane burns yellow. The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water vapor by the searing exhaust gases.

Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder. Spark plug electrodes are totally consumed during a pass.

After ½ way, the engine is dieseling from compression plus the glow of exhaust valves at 1400 degrees F. The engine can only be shut down by

cutting the fuel flow. If spark momentarily fails early in the run, unburned nitro builds up in the affected cylinders and then explodes with sufficient force to blow cylinder heads off the block in pieces or split the block in half.

In order to exceed 300 mph in 4.5 seconds dragsters must accelerate an average of over 4G's. In order to reach 200 mph well before half-track, the launch acceleration approaches 8G's. Dragsters reach over 300 miles per hour before you have completed reading this sentence.

The Bottom Line; Assuming all the equipment is paid off, the crew worked for free, and for once NOTHING BLOWS UP, each run costs an estimated $1,000.00 per second. The current Top Fuel dragster elapsed time record is 4.441 seconds for the quarter mile (10/05/03, Tony Schumacher). The top speed record is 333.00 mph. (533 km/h) as measured over the last 66' of the run (09/28/03 Doug Kalitta).



Putting all of this into perspective:

You are driving the average $140,000 Lingenfelter "twin-turbo" powered Corvette Z06. Over a mile up the road, a Top Fuel dragster is staged and ready to launch down a quarter mile strip as you pass. You have the advantage of a flying start. You run the 'Vette hard up through the gears and blast across the starting line and past the dragster at an

honest 200 mph. The 'tree' goes green for both of you at that moment. The dragster launches and starts after you.

You keep your foot down hard, but you hear an incredibly brutal whine that sears your eardrums and within 3 seconds the dragster catches and passes you. He beats you to the finish line, a quarter mile away from where you just passed him. Think about it, from a standing start, the dragster had spotted you 200 mph and not only caught, but nearly blasted you off the road when he passed you within a mere 1320 foot long race course./// BTW, i just checked the math on this and the above is correct... 200 mph is 293 ft/second. the dragster does 1320 ft in 4.4 seconds. the dragster would win by a tenth of a second... howard//

FrestyleFC3S 01-12-2004 08:38 PM

yo what the ****

FrestyleFC3S 01-12-2004 08:40 PM

oh and this is the oldest repost ever....you suck at GenD

Leetheslacker 01-12-2004 08:58 PM

you lose GenD!

defprun 01-12-2004 09:07 PM

shift_thisthreadisgay

teknics 01-12-2004 09:10 PM

my bologna has a first name, but we sold that bitch!



kevin.

Apex13B 01-12-2004 10:27 PM

lol i read that 2 years ago, and its ****** stupid btw

ColinRX7 01-12-2004 11:32 PM

Whew. Good think I didn't read it all. You guys saved me!!



THANKS, GEND!

Digisan 01-13-2004 01:31 AM

I thought it was cool, but I never seen it before. I guess I'm not as critical as others.

drifter 01-13-2004 06:32 AM

Way to flame the NewB.


All times are GMT -5. The time now is 04:41 PM.


© 2024 MH Sub I, LLC dba Internet Brands