I'm going to be putting in a "slightly used" short block in my car within the next week or so. What gaskets, seals, etc...will I need to get. I know the obvious ones like the LIM, UIM etc..., but what else? Here's what I have so far.
Gaskets: -UIM -Throttle body -LIM -Exhaust manifold -Down pipe -Water pump -Oil metering pump? ???????? Seals: -Injector o rings -Copper crush washers for oil fittings on block ????? MISC: -New thermostat -Turbo coolant hoses -Oil injector lines -Turbo studs -Mixing plate for injectors? What else do I need? Help a brother out https://www.nopistons.com/forums/pub...IR#>/smile.png |
thats a good list, you should additionally look at
the turbo pipe crush rings (if you have that apart) all the water hoses what about your clutch? mike |
Front seal on transmission
|
Originally Posted by j9fd3s' date='Aug 14 2003, 11:43 AM
thats a good list, you should additionally look at
the turbo pipe crush rings (if you have that apart) all the water hoses what about your clutch? mike The motor is only gonna be in there for maybe 2 months so I'm not gonna do a clutch or tear down right now. That comes later with a bunch of other goodies https://www.nopistons.com/forums/pub...DIR#>/wink.png Trans front seal? For the input shaft? |
Trans front seal? For the input shaft?
YES |
Originally Posted by 93 R1' date='Aug 14 2003, 10:46 AM
[quote name='j9fd3s' date='Aug 14 2003, 11:43 AM'] thats a good list, you should additionally look at
the turbo pipe crush rings (if you have that apart) all the water hoses what about your clutch? mike [/quote] yep, you might not have to touch those, just a thought mike |
anything else before I call Malloy?
|
i think you're good to go
|
All times are GMT -5. The time now is 09:06 PM. |
© 2024 MH Sub I, LLC dba Internet Brands