Been looking on the Net for ITB's and a Dry-Sump for an RX8 Renesis, but can't find anything.
Do these products exist for this engine? Brand new to Rotaries, so go easy on me! https://www.nopistons.com/forums/pub...IR#>/blush.gif |
Post here instead...https://www.nopistons.com/forums/index.php?showforum=81
|
Oops!
Thanks (again!) |
DIY! Motorbike throttlebodies and hack up the sump thats on it!
|
Hmmm... not sure about bike TB's. In fact, not sure about ITB's in general. Had a look at the induction ports on the block - what on earth is going on there? Holes everywhere!
|
Howcome?
|
I'm new to rotaries, so am struggling with the 'quirkyness'...
On a 4-cylinder engine, fitting ITB's to 4 equal spaced / sized in-line ports is easy. From what I can see on my Renesis, I have 6 ports - 2 small round one's each with a large round one below it, and 2 small oblong one's in the centre. Making an equal length manifold for that little lot is going to be fun! |
Suzuki tb's are seperate so you can have em any distance apart.
|
Done a bit of digging around and the general consensus from the 'experts' is that a Renesis engine would NOT benefit from independant throttle bodies.
If that's what the race engineers say, then it's good enough for me! |
Dont get confused between turbo setups and non-tubro ones. Talk to tyson on here, he had a similar setup iirc.
|
All times are GMT -5. The time now is 04:16 AM. |
© 2024 MH Sub I, LLC dba Internet Brands