Hey all

If u read my other post u know my project already, for those that havnt its fitting a 20b (may have to go 13b) into a renault 5.

A question for those in the know, i have rough dimensions for the 20b but wish to make certain on them b4 i go buying one, could do with knowing the width and heights from the bellhousing centre and the length.

Also the same for the 13b if anyone knows them, i may have fittment (size) problems with the 20b although i believe at a squeeze it will go in.





Cheers all brett

the 20b is the same as a 13b exept its longer. from bell housing flange to the water pump pulley its 24" long



mike

More info for you. It's exactly 160mm longer than a 13B because it has two extra 80mm housings. One is for the tension bolts and a stationary gear. The other is the third rotor housing. Just measure a 13B engine bay and add 160mm to it. Or not. https://www.nopistons.com/forums/pub...IR#>/bigok.gif You'd be amazed at what can fit in where with enough planning.

cheers guys, dont suppose any1 knows the distance from crank centre to lowest point on engine? just trying to figure if there will be any clearance problems?

Of engine or oil pan? From memory, it's like 7 inches or less.