hey all, how goes it... i am planning on putting a 13b tt into my 92 b2200.. first question.. will this be a fairly easy task, or will there be lots of custom fitting required?? thats all for now, all and any advice is appreciated..

I think from memory people use a 1st gen front cover so they can use the front mounts and weld up the brakets in the front.

They also use the bell housing from the TII trans because the trannies are the same I believe, except for the ratios.



Judge Ito would know. He built a 13 TII pickup and it was doing 12s and it was still running a stock turbo.



C

if you are good at fabbing you can make mounts to used the stock bolt holes for the turbo engine mounts. the B2600i tranny is the same as the turbo II and the b2200 and b2000 tranny are the same as the N/A trannies. First gen Rx7 LSD will fit in the truck's differential.