I bought a used PFC for my 94 rx7 and I have intake, DP, CB, and High flow cat on midpipe. I have heard that new...the PFC ships with some modified maps for intake, etc. The guy that I bought it from was running a single turbo. I have the stock twins. I installed the PFC and it would run on opt. 1 and opt. 3-5...but not opt 2...so I am assuming that he had option 2 re-mapped for his single turbo. Now assuming that he left opt. 1 as the base map (not that it matters cause I loaded a base map onto it). And assuming he didnt mess with options 3-5, which option/map should I run for my mods? Does anyone have a map that I could use...anyone with my same mods?



more specific on mods:



-custom intake (hardpipe and autozone cone filters.

-Mild steel down pipe (on the car when purchased).

-Blitz nurspec CatBack.

-High flow cat on midpipe.



Thanks,

Sean

option 1,2,etc... Is for different types of MAP sensors. Those are not the settings you should be changing. Only change those if you install a 3 bar map sensor. It should be set to "NORMAL".



As far as maps to use, I would do a reset of the PFC so the TRUE base maps are on there. They should be o.k. for your car. They were extremely lean on my car though. I have a FMIC in addition to the mods you have. I'd get it tuned by a professional if I were you.

Justin's right. https://www.nopistons.com/forums/pub...IR#>/boink.gif