I had a few problems while tuning and could not finish(secondary throttle plate linkage fell off). In any case, I noticed my temps were a bit high so i got out of and poped the hood...come to find my fans are not working...no biggie i got the fan mod and use it as needed just keep an eye on temps.

After i got the throttle linkage installed, i new problem reared its ugly head. I cannot rev past 2.5k rpms while boosting more than 4psi or so...It either dumps a boatload of fuel or cuts ignition not sure but i did notice my omp voltage on the sensor check feature on the PFC commander read 0.00 and highlighted. My question is could that be like my fans, something that can br turned on/off through the datalogit?

Lets say its the omp that went bad, how do I fix my problem and just run premix insted of buying a omp(not even an option rightg now)???

TIA,

if the omp is unplugged, or bad it will read 0v in the pfc and be highlighted

ah damn it! r u serious? this ******* sux!

make sure its plugged in

i was under the impression that PFC didn't care if the OMP was working or not. It will read the signal from it.... but not go into a "limp mode" like the stock ECU... is this wrong? If that is the case... there is an additional issue that is cause it to not rev above said RPM.....



unplug it... add premix.