NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   3rd Generation Specific (https://www.nopistons.com/3rd-generation-specific-18/)
-   -   temp light on, dash is beeping, but the needle is still moving (https://www.nopistons.com/3rd-generation-specific-18/temp-light-dash-beeping-but-needle-still-moving-54748/)

FikseRxSeven 11-06-2005 04:20 PM

so whats the deal?



i havent started the car in about a month, and today when i started it, its beeping, at first i thought that i must have nudged the sensor off the rear housing, but the needle is still moving.



any suggestions?

7passu 11-06-2005 04:30 PM

wire going to the coolant level sensor is broke or just low on coolant.... try to run a new ground wire to the sensor...located near the fill cap on the engine

Signal 2 11-06-2005 04:34 PM

edit

amp 11-06-2005 04:51 PM

without being too obvious..

have you checked your levels...

FikseRxSeven 11-06-2005 05:24 PM

water levels are all good, filler neck and resevoir... i dont have the ast anymore

7passu 11-06-2005 05:33 PM

i had a problem like that ...all i did was make up a ground wire for the water level sensor in the neck...and that fixed that...

FikseRxSeven 11-06-2005 05:39 PM


Originally Posted by 7passu' post='776111' date='Nov 6 2005, 06:33 PM

i had a problem like that ...all i did was make up a ground wire for the water level sensor in the neck...and that fixed that...



ill check it out tomorrow, so just cut and replace the wire right?





all i did was take off the UIM and injectors, didnt really touch more than that, i turned the car on several times to check fuel pressure, and i heard the beep assuming that its from the unclipped sensors on the UIM.


All times are GMT -5. The time now is 03:53 AM.


© 2024 MH Sub I, LLC dba Internet Brands