NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   3rd Generation Specific (https://www.nopistons.com/3rd-generation-specific-18/)
-   -   Some one please tell me i dident blow my engine! (https://www.nopistons.com/3rd-generation-specific-18/some-one-please-tell-me-i-dident-blow-my-engine-58968/)

fuse_d_m 04-29-2006 02:40 AM

cruising down the road and coming into a turn i decide to floor it in forst gear, pushing 1.0 boost on stock turbos street ported engine, brought it up to 8 grand rev limiter started cutting fuel got it into second and damn, rpms dropped in a nasty way, sounds hella slow on the throttle push the gas wait a few and rpms will come back up dont push the gas and it dies so i limped it back home and damn was it a bitch to keep in gear and tried to start it this morning and NOTHING wont fire up smells like pure gas coming from the exhaust. i think i may have flooded it by tring to start it to much but is it possible that maybe i just blew a spark plug maybe fouled on out to the opoint of the engine misfiring???? PLEASE SOME ONE HELP I DONT WANNA REBUILD MY ENGINE.

amp 04-29-2006 05:52 AM

unflood the car and check your plugs..

replace em... check your map sensor as well...

might as well do a comp test while you have the plugs out...

qwester007 04-29-2006 02:16 PM


Originally Posted by amp' post='816559' date='Apr 29 2006, 06:52 AM

unflood the car and check your plugs..

replace em... check your map sensor as well...

might as well do a comp test while you have the plugs out...





My thoughts exactly-

willjs7 05-01-2006 07:28 AM

how much vaccume is it pulling?

FUSEDM 05-01-2006 12:11 PM


Originally Posted by willjs7' post='816876' date='May 1 2006, 09:28 PM

how much vaccume is it pulling?





Cant get it started but i have a feeling it might be one of the ignition coild gone bad cause it making all kinds of noise see other post.

black93fd 06-26-2006 02:23 AM

yea it sounds like its flooded. go to rx7.com and go over there procedure for unflooding the 2nd gen motor its the same as the third gen, and then try it. I doubt that you could even drive it home if you blew your motor which most likely would be a blown apex seal but if you had a really rough idle then you may have blown an apex seal and will require a rebuild. good luck


All times are GMT -5. The time now is 05:42 PM.


© 2024 MH Sub I, LLC dba Internet Brands