Okay I got the differential, 2 new bearings and 2 gaskets for each side where the drive shaft attaches. So all i have to do is unbolt the rear housing and the bearing cap and the diff should plop right out? Then i have to get the new bearings pressed onto the new differential and swap the shims from the old diff to the new one. Is that all I have to do? The shims are what sets the pre-load correct? I'm assuming there is no need to change the shims if I'm just replacing the differential and nothing else.
Thanks |
All times are GMT -5. The time now is 09:13 AM. |
© 2024 MH Sub I, LLC dba Internet Brands