TO4R

550 Pri

1680 Sec

SX regulator



Need a good pump... Was going to get a nipondenso... Just wondering what is recommended. https://www.nopistons.com/forums/pub...#>/biggrin.png

I have all the smae mods as you. I got a walbro. plenty of fuel

The biggest loudest **********er you can find. You could hear SPEEDNYC's fuel pump from 50 ft away while the car was idling, when we were at rotorfest, no joke https://www.nopistons.com/forums/pub...IR#>/smile.png



Nippon or walbro should be o.k. unless you plan on running 20+ psi but then you would need bigger primaries anyway.

Thanks guys!

https://www.nopistons.com/forums/pub...IR#>/bigok.gif Go down to your local Toyota dealer for 94 Supra pumps.

https://www.nopistons.com/forums/pub...IR#>/blink.png



How do you wire up something like that??

I would'nt think you would need any type of dual pump unless you wre erunning super big lines and major boost

E11 has primary pump wiring plus an output for a secondary pump relay.



I wired one with the Haltech gear, then put another relay in drawing power from the stock fuel pump fuse. My stock fuel pump wiring should be removed, but at least it isn't a hot circuit now.



Each of those pumps draws 12 amps, so you can't just pop them in the stock circuit.



As for connections at the tank.....

Very nice. You'll need that once you crank the boost up. ****, I'm gonna need something like that soon.

Badass.

I'm planning on doing this type of setup very soon, only with two walbros. Anyone know how to wire them up?? not useing a Haltech..

going to be running 2 walboro's as well since 2 FD pumps that flow 340 lph isn't enough https://www.nopistons.com/forums/pub...IR#>/angry.png



It's cake to run...I'll take pics of it when I get my walboro's in. https://www.nopistons.com/forums/pub...IR#>/bigok.gif

Use the existing fuel pump wire to open a new relay big enough for both pumps. Then fuse and wire the power side of the relay directly to the battery.

that plate is PIMP

Check this out. Mine was my prototype, the 2nd one of the final design went to RX-7 Specialties and got in Modified mag!

cool. i like my sump but if i ever had to change i'd go that route but with two bosch motorsports pumps

sweet man.. you know i have problems with anything to do with electricity on my car. https://www.nopistons.com/forums/pub...#>/biggrin.png