Hi, I am new to this forum. I have some problems with the Racing Beat Rear Sway Bar, which I have just fisnished installing.



The bushings that came with the rear bar appear to be slightly too small, and there is a big gap in the bushing after I screwed on the oem bar bracket. Please see photos. Is this normal?

Another Picture.

they didnt come with oversize brackets?



my prothane bushing kit did.......weird....

No, they didn't come with new brackets. Only two bushings, which when placed on the bar left a big gap in the bushings. I also installed the RB Front Sway Bar and the bushings fit perfectly, as shown below.

something is wrong, there should not be an open spot like that'

i had the same problem with them. i think rb sell the bracket that would fit their bushing. give them a call

I called RB and they told me that I was given the Miata bushings. They (with the help of RX7 Store as I purchased the kit from them) did however expressed the right bushings to me. Excellent service by RB and RX7 Store. https://www.nopistons.com/forums/pub...IR#>/smile.png