NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   3rd Generation Specific (https://www.nopistons.com/3rd-generation-specific-18/)
-   -   Porting intake have some questions. (https://www.nopistons.com/3rd-generation-specific-18/porting-intake-have-some-questions-7794/)

Jims5543 11-13-2002 10:02 PM

I am porting my FD intake and have a few things that I have run into that I hope some of you can help with. I will post pics tomarrow to help clarify what I am talking about.



There are 2 sets of butterfly's 3 on the throttle body and 2 on the plenum. I want to remove the 2 on the plenum are they absolutely neccesary??



There was another issue too but I am too tired to remember. I will try to post some pice tomarrow and ask the other question then.



FYI - I am removing all emmisions and installing a haltech and a T-o4E single. So anything on the intake that can be plugged or removed feel free to pipe in and tell me.

P'cola FD 11-13-2002 10:16 PM

The butterflies in the UIM can go, just plug the holes from the rod. You can block off the ACV, AWS, EGR, split air thingy, and even IAC if you want. Also, you can bock off the OMP. Make sure to premix now.

Jims5543 11-13-2002 10:24 PM

Will haltech control the OMP??



BTW - Thanks you were really helpfull.

P'cola FD 11-13-2002 11:16 PM

I don't think the Haltech can control the OMP, hence the need to block it off, and run premix. Which is an acceptable loss, considering the advantages of the ecu.

Jims5543 11-14-2002 08:04 PM

Can someone help fill in the blanks I cannot figure out a couple of these.



Thanks.





UIM - ?

ACV - Air control Valve

AWS - ?

EGR - self explanitory

split air thingy - from the pollution pump

IAC - ?

OMP - oil metering pump

Fd3BOOST 11-14-2002 08:14 PM

UIM..Upper intake manifold

AWS...Automatic warm start.. You know how your car will rev at 3k when you start it cold..Totally unnecessary

IAC? I am drawing a blank.. What is that abbr. ?

Fd3BOOST 11-14-2002 08:15 PM

Intake air control maybe?

Fd3BOOST 11-14-2002 08:19 PM

https://www.nopistons.com/forums/upl...1035616580.jpg



Here is a pic of my double throttle removed. You have to drill out the little phillips head screws that hold it in. They are flattened into place.



You should check the thread about this and porting in the performance mods area.

P'cola FD 11-14-2002 11:33 PM

Dave is indeed correct. Idle air control valve.

Jims5543 11-15-2002 04:41 PM

O.K. Here is a pic of the bottom of the intake. Can I remove these actuators??



http://www.teamfc3s.org/forum/attachment.p...s=&postid=63924





I do not know why I cannot post an image or even ling in an image hosted elseware but here is a link to the pic.


All times are GMT -5. The time now is 11:12 AM.


© 2024 MH Sub I, LLC dba Internet Brands