Hi guys,



Just got new guages Defi look alikes



Oil Temp

Water temp

Oil pressure

Air/Fuel Ratio

Boost







Need help with first oil temp and water temp gauge.... in the package they have included some metal sensors and i do not have any idea where to put them? Do i need to drill holes in places to put them in? if yes where??



Also with the oil pressure guage there is a oil pressure sending unit.. How do i install that??



Need help..



Thanks

Not to be an ass but you might want some more common know how before you try modifying your car. When adding a sending unit for a temp guage you generally have to drill and tap the hole. For the temp guage I would put it in the front of the filler neck. Don't forget to take the radiator hose off for that. We wouldn't want metal bits getting in the coolant system would we? You can add the oil gauge sending unit into the oil filter pedistol. I know that greddy have an adaptor you can buy to fit the sender because I just bought one. The same with the oil pressure gauge.

I like to play safe by taking as much advice as possible



Thanks for the info.. I know now where i have to put the water temp sensor but am confused about the oil pressure and oil temp... is the greddy oil filter block adaptor a must to install these gauges??

That I don't know for certain. It would not be an issue to install the sending unit with the engine apart but i don't see how you would keep metal shavings out once she is assembled.

water temp usually goes in the water pump housing area ... it did on my FB anyways ... i know theres no place on the rad for it so , either water pump or near the rad cap area ...

http://www.rx7club.com/showthread.ph...hreadid=247152



Rotorfreak,



Appologies for linking another forum, but I'm getting ready to do 'D' series temp guage too. I know you said you know WHERE to mount the sensor, but in case you have a question of HOW, I found this pretty helpful. Good luck.

You might have to get a little smaller oil filter with greddy plate. It is a tight fit under the intake manifold. They also sell a type that threads into the engine feed line from the oil coolers. It has two spots for oil pressure and temp.

anyplace you can tell me where i can get the one that connects to the oil cooler?



thanks