willjs7 |
07-28-2006 08:42 PM |
I started the install of my FC1000 by mounting the ignition box under my RE-Amemiya headlights, i ran the power wire to the positive terminal and the negative wire to the grounding terminal on the battery. I mounted a Turbo 2 coil on the stock location with a little bit of modification to get it to fit right. i cut the clip off the stock harness for the leading coil and connected the red wire to the black and red wire on the harness, and the green one to the other wire. I used the spade clips and hooked up the positive and negative terminals on the coil. after all mounted up, in the on position the red and green wires both had 12+volts. But no spark. I put a new set of plug wires on thinking that might help. no luck, i tested the ground on the coil bracket and it wasnt grounded, i made an external ground strap and grounded it to the fire wall. Still no spark. fuses are all fine, Trailing coils are fiering. tested the T2 coil, checked out OK. any sugestions, im quite stumped at the moment.
|