NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   3rd Generation Specific (https://www.nopistons.com/3rd-generation-specific-18/)
-   -   Expected Oil Pressure? (https://www.nopistons.com/3rd-generation-specific-18/expected-oil-pressure-22702/)

Stang94GT 08-13-2003 10:04 PM

Sorry guys, I did a search and had trouble finding the info I am looking for.



What is everyone seeing for oil pressure? Based only on the stock oil pressure gauge, I am seeing ~15psi @ idle, fully warmed engine. I am using 10w30 Mobil 1 synthetic. While driving I easily see 60+ psi and the oil pressure moves with rpm fairly consistently. Is this normal? It just sounds awfully low to me.

wraith 08-13-2003 10:12 PM

it really depends on speed. you can see it go to all the way up when closer to red-line. you usually see around 50 to 60 just cruisin at speed.

toddp31 08-13-2003 10:19 PM

I see around 4bar at idle about 60psi, I also have the upgrade thermo pelet. The stock gauge is way off, when my greedy shows 4bar the stock isn't even above 2bar.

Stang94GT 08-13-2003 10:23 PM

I did a little reading on the thermo pellet - is this considered a must for every car? I don't know that this car has had that service.

jspecracer7 08-14-2003 03:14 AM

where are you getting the reading from? The stock gauge?

Stang94GT 08-14-2003 06:36 AM

Yes, the stock gauge. My only aftermarket gauges are boost and water temp.



edit: It's not the pressure at speed or cruising that concerns me. It's the ~15psi that I'm seeing at idle that concerns me. OEMs typically don't give you functional gauges.. they're just dummy gauges set to somewhere in the normal range with very little sensitivity other than at the extremes. This oil pressure gauge seems pretty functional to me.

jspecracer7 08-14-2003 07:57 AM

well, when I had a stock motor, my oil pressure on the stock gauge was set at 0 psi...but on my Defi gauge, it read 30 psi~ both at idle.



Now my stock gauge reads 30 psi~ and my defi gauge reads 60~...at idle. https://www.nopistons.com/forums/pub...IR#>/wacko.png

Sinful7 08-14-2003 11:51 AM

I typically see a very low reading (~5PSI) on the stock gauge whenever there's a high ambient tempature. Normally, however, I would guess that the 15PSI is where mine sits. The only times I see higher PSI at idle is on fresh oil or immediatly following startup. Also, I've noticed that at the end of the oil's life, the gauge will read very low, I seem to recall ~5PSI position..


All times are GMT -5. The time now is 11:25 AM.


© 2024 MH Sub I, LLC dba Internet Brands