i just got done rebuilding my OS GIKEN TWIN PLATE and replacing the throw out bearing, now my clutch pedal is real real REAL soft horribly soft before it was real stiff like work out stiff it was nice why is my pedal so soft now i adjusted the pedal but no matter where i adjust it to its still soft. ps when i dropped the tranny i dident disconnect any lines.
|
Originally Posted by FUSEDM' post='804442' date='Feb 26 2006, 09:16 AM
...ps when i dropped the tranny i dident disconnect any lines.
good excuse to get new fluid in there... |
did the engagement point for the clutch change?
|
Originally Posted by FikseRxSeven' post='804447' date='Feb 26 2006, 11:53 PM
did the engagement point for the clutch change? ITS ABOUT 1/4 INCH FROM THE FLOOR:( WITH THE PEDAL ALL ADJUSTED ALL THE WAY OUT CAPS ARE ALL I CAN USE AT WORK HARD TO SWITCH PLEASE BEAR WITH ME AND DONT THINK IM LAME |
Got it it turned out to be the slave cylinder the jam nut came lose and it was sitting back way to far. thanks everyone
|
what do you mean the jam nut? the piston in the rubber thing?
|
yeah, if you take out the piston the rounded portion on the top is heald in place by a nut under it called a jam nut, driving beautifully like a new car.
|
where in Japan are you at?
|
Mainland, NAF Atsugi in the city of ayase bout 4 trainstops from yokohama.
|
I ahve the same problem with my 89. the clutch is engaging about a 1/4 inch from floor. Do you think that my issue is like yours and if so should i replace the slave cylinder?
I just got the car yesterday and don't know much about RX7's yet. |
All times are GMT -5. The time now is 09:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands