Hi all, i have finished putting the motor back in and i have this plug left over. Any ideas as to where it goes? Its a 2000 model auto. Any help would be appreciated.



THis is the plug:

[attachment=45615:SDC10833.jpg]

and another shot:

[attachment=45616:SDC10832.jpg]







Also have another question, i took the car for a test drive after putting some k's on it and it has a knock sound at about 2000 rpm and up if i start to boost it (im only letting it boost to about 4-5 psi). I have the knock sensor installed. Any ideas?



The car idles perfectly and it drives very well.



I also noticed that when i installed the motor and started it up, the knock sensor was not connected. What worried me is that it didnt show an engine light. Is this normal? I would have thought it would have shown one if the knock sensor wasn't installed.



Thanks

also, i have a feeling i messed this up, where does the vac line from the fuel regulator go to? i have it on the manifold but im sure it wasnt there initially.



heres another pic:

[attachment=45618:SDC10837.jpg]





cheers

Also the engine light will not come on at all, and im having trouble getting it to flash any codes. Is the series 8 diagnostic process different?



Thanks



BUMPBUMPBUMP

does anyone know what would be causing the 'lean' condition? bad timing? fuel reg plumbed from wrong place? Bad earth?