i bought a used motor off ebay and the rear rotor is bad and i still have my motor the rear rotor is good so if i buy a gasket set could i swap rotors and housings? and how hard is it? thanks dan https://www.nopistons.com/forums/pub...IR#>/angry.png
|
Originally Posted by broken93rx7tt' date='Jun 16 2003, 07:53 PM
i bought a used motor off ebay and the rear rotor is bad and i still have my motor the rear rotor is good so if i buy a gasket set could i swap rotors and housings? and how hard is it? thanks dan https://www.nopistons.com/forums/pub...IR#>/angry.png
|
what do u mean in spec yes i know a full rebuild thanks dan
|
there are several measurements that need to be taken for clearancing and such.
|
help please
|
Originally Posted by broken93rx7tt' date='Jun 16 2003, 08:19 PM
help please
www.iluvmyrx7.com you can find all the clearances on the manual.. you might also want to think about buying the 30$ video from atkins rotary which goes step-by-step on a 13B rebuild. https://www.nopistons.com/forums/pub...#>/biggrin.png |
thanks dan
|
Originally Posted by broken93rx7tt' date='Jun 16 2003, 08:38 PM
thanks dan
|
yes thanks
|
Originally Posted by twinturborx7pete' date='Jun 17 2003, 12:40 AM
i'm hoping your name is dan? https://www.nopistons.com/forums/pub...R#>/unsure.png
https://www.nopistons.com/forums/pub...1047683664.gif i *may* attempt my first rebuild this summer. It depends on my job status and if i cand afford/ find a good used motor. |
All times are GMT -5. The time now is 09:42 AM. |
© 2024 MH Sub I, LLC dba Internet Brands