NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   Wtf Happened? (https://www.nopistons.com/2nd-generation-specific-17/wtf-happened-41333/)

sectachrome 06-30-2004 04:54 PM

ok so im coming home from the skatepark, and i stop at 711 for a slurpee. i come out, try to start it, nothing, absolutely nothing. didnt even try to turn over. the battery was fine. i called some friends and neither of them had any idea either. we sat around for a while waiting for a towtruck my mom called, and i tried starting it again, and it started right up. perhaps something electrical overheated?

1gendreemer 06-30-2004 04:59 PM

Check the connection on the starter or the starter itself. Mine did that on it's way out....if you would bang on the starter with something it'd start up fine.

spaceman Spiff 06-30-2004 05:15 PM

yea id say check the wire going to the coil.

Shane.Trammell 06-30-2004 05:25 PM

the starter is prob about to die. its just putting in its 2 week notice. sometimes they quit before the 2 weeks is over though

sectachrome 06-30-2004 06:08 PM

hmmmmm....****. about how much do starters+labor go for these days? im hopin 10....15 bucks...

SPD Racing FC 06-30-2004 06:45 PM

the install on a starter is real easy, you can get a used one but who know's how long that will last

sectachrome 06-30-2004 06:49 PM

how easy? the most work ive done on my car so far is change the oil and air filter....

ColinRX7 06-30-2004 07:06 PM

Starter is an easy job



It's likely the starter going out (I know I'm repeating what others have said but that's the case, just to let you know).



Disconnect the battery negative terminal



Go under the car (jack it up if you don't have enough space).



Take the wires off the solenoid for the starter (A negative, positive, and small wire to trigger the circuit)



Two bolts to undo the starter. The upper bolt you need to hold a wrench over on the engine side (it's a long bolt).



Then the starter is out, replace with new. Installation same as removal

ColinRX7 06-30-2004 07:07 PM

Ask your Dad or something if you are unsure of anything. All starters are the same essentially. Even if you forget which wires go where, just about anybody who has mechanic experience can tell you where they go.


All times are GMT -5. The time now is 02:29 PM.


© 2024 MH Sub I, LLC dba Internet Brands