i finished my engine swap and now i can't figure out the windshield wipers!! someone told me to just remove the wiring from the N/A harness but after doing that there is no spot for me to plug it into!!! so what are my options cause i really need my wipers to work, lol.

What type of dash harness do you have, JDM or USDM? I don't mean the engine harness.





I have a diagram at home of the wires from the wiper motor (5 wires, I believe), and where they plug into the dash harness.

the jdm harness runs to the us drivers side of the car, so it doesnt do the wipers. you need to pull off the 6-8 wiper wires out of a us harness (they built it so that the you can just follow the wiper plug), and plug it into you car

Of course there is a spot to plug them in, they were plugged in before.



I dont even have an engine harness in my car anymore. I just separated the wiper wiring fromthe bundle.



If I recall, the TII may have a separate bundle for the wipers.

i am using the USDM dash harness and the plug for the wipers is being used by the JDM engine harness since on the USDM harness the wiper plug was part of it.

Dont ask about a honda on a rotary forum by resurecting ancold thread

It's a spam post.