Rear Camber Ajust.
12-21-2012, 10:01 AM
#1
Junior Member
Thread Starter
Join Date: Dec 2012
Location: Millville, NJ
Posts: 9
Rear Camber Ajust.
Can some one tell me for sure which ajuster in the rear ajust the camber? I have an ajustable link that goes from the chassie to the rear sub frame, and then two excentric looking ajuster's on the lower arms up where they attach to the body, which one is which.I know one is for toe and one is for camber but which is which.
12-24-2012, 03:39 PM
#4
Senior Member
Join Date: Dec 2008
Location: Folsom, CA
Posts: 737
Re: Rear Camber Ajust.
no prob these also exist
Rear Camber Links
Rear Camber Links
Our camber links allow for independant adjustment of camber on each rear wheel. They replace the non adjustable OEM links found at the rear control arm inner mounting point. They can be lengthened to increase negative camber or shortened to reduce it. Our links are manufactured 6061-T6 aluminum and 303 stainless steel. The spherical rod end is teflon lined and made from chrome-moly steel with a hard chrome finish.
THESE LINKS ARE NOT COMPATABLE WITH DELRIN OR POLYURETHANE REAR CONTROL ARM BUSHINGS. THEY MAY BE USED WITH OEM RUBBER CONTROL ARM BUSHINGS OR WITH MMR SPHERICAL CONTROL ARM BEARINGS. from MMR-Direct but also a few other companies prob they replace the 2 little links the go subframe to control arm in the rear
Thread
Thread Starter
Forum
Replies
Last Post
mx6-mike
3rd Generation Specific
1
06-13-2003 12:22 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)