im gonna have to replace my driver's side fender real soon. the thing is i got every bolt holding it on but those clips that hold it on in the front. nt to mention about every bolt on the bottom snapped due to rust. so do u think a can tap them and reverse them back out with a tap and die set? how do i get these out? and do those clips have anything to do with mounting the bumper?

thanx

bump

you mean bolts? yeah the bottom 2 you can drill and tap. the front ones are studs on a plate, id just get a new plate its cheap

these are the clips i was talking about. they are on the front end holding the fender on. are they also used to attach the bumper? this pic has two out of the three of them. there is one more above the one on the top.

yes they hold 3 peices together (bumper/support/fender)



if they broke just cut them off and drill a hole and use a normal 10m



weld the one side so it will not rotate.

Just replace that whole piece from the dealer. Those always break.

no i dont know if u understood. i want to take them off so i can take the fender off. they are the only things holding the fender on.

if the nuts are off them then take the fender off, you will have to take the bumper off first or try to pull the one side of the bumper

out. Those studs come out with the bumper



those strips are like $14 from Mazda