I'm working on a bunch of long over due projects today, one of which is replacing the shifter bushings in the T2. When I pulled the shift lever out, I was surpised to find that there where no bushings in there at all. No wonder it was sloppy.
I had purchased what I believed to be all the peices nessescary, but now I'm not sure. I have the follwing bushing set... http://mazdatrix.com/faqpics/shiftbsh/shift02.jpg I didn't know this set existed until I found the Mazdatrix FAQ.... http://mazdatrix.com/faqpics/shiftbsh/shift01.jpg Do I really need the bottom set also, the white bushing? Or will the top or blue one do for now? I looked down in the hole for the old bushing or even remnants of it. Vanished! Where da hell did it go? |
The pieces of the bushing have fallen down in the trans. I would replace both upper and lower bushings at the same time to avoid any uneven wear on the new pieces.
|
You will need both, as the top sits on the lower. Mine broke off an fell into the shifter linkage, not allowing me to shift...
|
I believe you need all the bushings in the Mazdatrix set https://www.nopistons.com/forums/pub..._DIR#>/dry.png
|
I made the mistake of only putting on the top 3, and my shifter was worse than before I changed them. Too bad the old bushings fell out in a million (okay, maybe only a hundred thousand) pieces.
|
All times are GMT -5. The time now is 04:29 PM. |
© 2024 MH Sub I, LLC dba Internet Brands