So I am removing all of my ABS sensors for Ric and the front 2 were cake, the rear is a different story! So a couple of things, the FSM is retarded in the fact it doesn't tell you nut and bolt sizes So I got the 32 MM socket and removed the nut. After much cussing and kicking I got the whole rear hub assembly off the car, I will have a write up on it later. So now I need a special tool to remove the hub from the carrier, which I obviously do not have. Does anyone know of a tool that I can use to separate these two pieces that will not damage anything? I have looked on MazdaTrix for the SST but they did not have it. I am sure I could buy it from Mazda but it would cost a fortune. Does anywhere sell this SST at a discounted price? I am not a member of MazdaComp anymore since my car is dead. Can anyone order it for me?



Thanks,



Eric

Update. In the dtss eliminator instructions from racing beat it said you could pop the hub off using the screws that held in the rotor. Well, I read it wrong, they said that you can remove the ROTOR with the screws if IT is stuck on. They said you can take out the screws and then thread them in from the rear and pop the rotor off. The only problem is, you cannot do that with ABS because the ABS rotor is blocking the hole where you thread in the screws.



I guess you need a puller or press.