Some questions for the rotor heads out there... I have a 86 NA At and want to swap to T2.... First is the diffs the same ie bolt in.... and the driveshaft? the T2 is stonger but shorter that a At one...... so can I get the J-spec 5 sp T2 driveshaft and diff......and of course the counterwieghts! and help is welcome!!!!! https://www.nopistons.com/forums/pub...1047683894.gif

its a bolt in procedure, you will need the driveshaft from a TII and a crossmember from a manual if im not mistaken,

You'll need the TII transmission, flywheel, clutch, starter, driveshaft, rear end, and axles. The last 3 are optional if you go with a custom driveshaft. Don't forget the slave and master cylinders, as well as the pedals. I don't think that the TII transmission and mount will bolt right in. I think that the mounting holes on A/T frame are in slightly different spots.

we miss Ace and his precision, hence the reason he is the 13b Ace!

I am the everything Ace!!! https://www.nopistons.com/forums/pub...#>/biggrin.png By the way, how do you like my new title?

I like it alot

Ace is the place for hardware https://www.nopistons.com/forums/pub...DIR#>/wink.png

on the trans mount, will there be hole availible from factory?/ Aftermarket source? or( last option) is there a safe way to Fab? Once again thanks for all of everyones' help!!! BTW I also need the right counterwieghts right?

If I keep the at and use a TII rearend what drive shaft do I use?

a custom one

No the T2 driveshaft will not bolt in to the NA diff. You will have to take the the drive shaft ot a driveshaft place and have the T2 driveshaft modified to a na folk at the diff end.



I' ve heard the mounts of the chassis AT are located differently than na cars so that would be the other problem



C

Ups I mis ready, If you are going with a TII diff you also need the TII half shaft since they are bigger when they hook up to the diff.

i too am doin a swap like this. if someone can help me with all the details please send me a message. i just blew my n/a tranny so now im bout ready to do the swap. i have the n/a manual tranny, and i know i'm gonna need the tII cross member. but i got to lookin at the tII diff and it seems a little different in how it mounts up. like i said can some one message me with all the details of the parts i need. thanks.

Get the whole tranny , driveshaft, Diff and half shafts from a TII and also the S4 flywheel, starter, clutch slave cylinder, and tranny mount also. Itshould all bolt in then https://www.nopistons.com/forums/pub...1047683473.gif

can you not read 13B ace's post in this thread? He lists all the parts needed. https://www.nopistons.com/forums/pub...1047683561.gif