NoPistons -Mazda Rx7 & Rx8 Rotary Forum - quck question on wrench size

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)

- 2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)

- - quck question on wrench size (https://www.nopistons.com/2nd-generation-specific-17/quck-question-wrench-size-66269/)

as topic says boys i got my steering angle spacers and hardened tie rod ends (GP Sports super angle kit) and went to install them and found out i need a thin wrench, so instead of spending 385 on snap ons kit (only ones i found to make them in metric) what size is it so i only need to buy one!!! anybody know???

thanx in advance!

Just use a monkey wrench with something to keep the shaft from twisting. Or get a cheap wrench and grind the side till is thin. I just did mine this week.

Use some mediem treadlocker to keep them in place.

C

Quote:

Originally Posted by Ricer240sx' post='875289' date='Jun 16 2007, 06:48 PM

well now i ran into another problem...is the threading on the pass side thicker or is there a threaded insert thats put in on that side??