ok i will be taking some of yalls advice and install a 5spd (exhaust will have to wait just a little while) some time soon i have done 7 engine swaps but no trans swap and would like some of you to help if you could. would any one have a write up or could some one tell me the parts i would need any help would be appreciated also could i fit a t2 manifold to my se or do they have different bolt patterns well im off to read my haynes manual https://www.nopistons.com/forums/pub...#>/biggrin.png
Thanks David |
t2 lower intake manifold is a 4 port vs 6port n/a intake manifold, it won't work..
You need the pedals/tranny/driveshaft/hydralics and you'll have to have holes drilled for the tranmission mount, since the mounting points are different.. |
sorry i ment to say turbo manifold will the turbo manifold bolt up? so the engine to trans bolts are the same between the auto and 5spd?
|
Originally Posted by FrostRacing' date='Aug 25 2003, 06:52 PM
sorry i ment to say turbo manifold will the turbo manifold bolt up? so the engine to trans bolts are the same between the auto and 5spd?
The tranny will bolt right up, I dunno if the same bolts will work.. More than likely they will.. |
do you know if i will have to cut a hole in my floor to install the pedal ?
|
I think it's already there. You might just have to punch it out.
|
the tranny doesn't bolt right up, the mounts are in different places, you have to drill out the tack welds holding the tranny mounts in place on both the automatic and 5 speed then weld the 5 speed mounts into the car being converted over.
|
All times are GMT -5. The time now is 01:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands