Trying to be thorough about replacing old vac lines, I pulled the lines off the MOP injectors and set about replacing them. There is a little four-into-one vac fitting that they all connect to. I was able to pull three of the old lines off successfully, but the fourth was so heat-fused to the plastic that I ripped the nipple right off (OUCH!)



Does this thing have a part number? Anybody ever seen anything like it in an auto parts store?



Thanks!

n326-14-617

Thanks! https://www.nopistons.com/forums/pub...IR#>/bigok.gif

yahssir!

premix damnit!

I guess I could add a little premix too.



With the existing MOP, I figure it ain't hurting anything to leave it there.

well if it's leaking or any lines break, you might as well save your money and just slap a block off plate on there.