NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   Overheated, Well Sort Of... (https://www.nopistons.com/2nd-generation-specific-17/overheated-well-sort-46590/)

phinsup 03-27-2005 08:18 PM

I am hoping I got lucky, here's the deal, sitting at a light, notice the temp guage is at about half, which is not normal, I proceed to the nearest pull off area and it's just a hair above half, holy ****, I got steam rolling out of the hood, I am in a panick figuring I fucked a brand new motor, pop the hood start dumping water on the motor, notice the steam is coming from the upper radiator cap WTF?



Somehow the upper cap got cracked loose, no clue what happened there, tighten it down and the temp guage was already down, strange thing is it went down the minute I shut it off.



I'm hoping it didn't do any damage, still runs great, but was not fun. I'm guessing since it didn't really reach the boiling point it will be ok.

vosko 03-27-2005 08:24 PM

my old ito built FD motor was overheated NUMEROUS times and was fine.....if it runs the same its fine

j9fd3s 03-27-2005 08:43 PM

my mercedes did something like that, i added coolant (it leaks), and rechecked it the next day. i opened the hood and the cap was gone, so i ordered a new one, open the hood the next day cap falls out from the hood somewhere https://www.nopistons.com/forums/pub...IR#>/blink.png



its a good thing the cap on that car only keeps the coolant from falling out and not the car overheating

phinsup 03-27-2005 08:51 PM

yea i dont think it really overheated, I am not sure, like I say still runs great, the worst case was the temp guage got to under 3/4 assuming the cap had been on there wouldnt have been any steam.



It still runs great so I am hoping to hell I am ok

j9fd3s 03-27-2005 09:09 PM

it should be ok, H=235f so under that is hot but prolly not dead

drftk1d 03-28-2005 12:57 AM

mine was at like 5/8 the other day.



not like i care...

knonfs 03-28-2005 06:48 AM

[quote name='vosko' date='Mar 27 2005, 10:23 PM']my old ito built FD motor was overheated NUMEROUS times and was fine.....if it runs the same its fine

[snapback]691607[/snapback]

[/quote]



Same here, my current engine temp gauge went all the way up a couple of times before I figured out what was going on with the cooling system; still running without a problem.

phinsup 03-28-2005 07:08 AM

whew, sounds like I might be ok then

SPD Racing FC 03-28-2005 12:54 PM

i've ran mine that high before you should be fine

Baldy 03-28-2005 01:01 PM

Got mine to 3/4, remember the bad thermostat? Ran fine after that, until I blew the oil cooler line. Have you changed the t-stat recently?


All times are GMT -5. The time now is 05:43 AM.


© 2024 MH Sub I, LLC dba Internet Brands