okay so i made a coustom switch panel that goes in place of the original plastic bezel in the center console. heres what i have so far but i cant decide if i would like it better if i painted it black, or just leave it alone (sand blasted aluminum). soo whats ur opinion?

Looks good but what are the 3 buttons for

paint it. it will look too out of place other wise IMHO.

Unless you got other aluminum pieces

Id paint it, id hate to see the glare off that from the sun.

Id say leave it let the person who gets it decide

the swittches are for the fuel pump, led drving lights behind the FTPs and maybe a set of fog lights. i have othe aluminum peices but not much. im jist gonna paint it black then ill take pics nd post them, if its not liked ill sand blast it back off

I'm just going to redo the entire dash with aircraft grade sheet aluminum and gauge and switch panels ripped out of an old military transport lol

ok here it is in black (just quickly sprayed it), i like it better this way so im gonna strip it back down and do a better job. one more question tho, anybody know of a good textured flat black paint?

The dupli color engine paint

VTH makes a very high quality textured paint. but the piece must be preped properly

Well any surface must be prepped well for it to be nice

VHT is one of thoughs paints you must prep the way they say or it wont lay right, other paints you can short cut some , VHT is not one of them

ahhh i need to redo my calipers brake fluid ate them up a bit