did that saturday no luck

ok did emissions per rotary ressurections

found new tdc per another site ohmed out coil pacs and cas checked fuel checked compression and still nothing

ok so my fuel pump was not cutting on got a new one and still no fuel pump noise but i smell gas when turning ove r with the ocasional pop pop but still no starting

Fuel pump relay. Its located behind the pass bumper, below the air box bolted on the the framing(two 10mm i think).



https://i446.photobucket.com/albums/...sistorpage.jpg



The read circle: The fuel pump resistor inspection steps(Duh)



The red box: Is the Ristance ranges (Duh) if there out just a few places it most likely isant yur problem but itf you find one cheap thats with in range pick it up.



The green circle: The Relay. If you open it up (the 8 little metal clamps) there should be no forgien material (water rust debris ect.)Just another place to look.

thanks had not seen that anywhere ill try it and let you know