NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   next step!? (https://www.nopistons.com/2nd-generation-specific-17/next-step-56644/)

sonick117x 01-23-2006 06:56 PM

i have a 90 gtu.. i wanna know what i should do next as far as mods.. i just finished putting in a more open exhaust including rb headers and custom piping with two fat magnaflows in the back.. whats next ?

cps87rx7se 01-23-2006 09:45 PM

Intake would be the next thing that I would do.

RONIN FC 01-24-2006 10:50 AM


Originally Posted by sonick117x' post='795944' date='Jan 23 2006, 07:56 PM
whats next ?

Thats it, yer done..

One320B 01-24-2006 11:02 AM

k&n filter and nitrous.



or pull the motor and go to town.... the stocker NAs don't have much to offer IMHO on the stock setup. Full standalone, exhaust, and a good port job will net anywhere from 160whp to 300whp depending on your port job...

sonick117x 01-24-2006 11:12 AM


Originally Posted by One320B' post='796058' date='Jan 24 2006, 12:02 PM

k&n filter and nitrous.



or pull the motor and go to town.... the stocker NAs don't have much to offer IMHO on the stock setup. Full standalone, exhaust, and a good port job will net anywhere from 160whp to 300whp depending on your port job...

whats the potential whp without swapping a t2? what do you think an NA could pull? and do you happen to know of ANY shops that could port and rebuild my engine in the trenton nj area or anywhere close? thanks!

One320B 01-24-2006 12:22 PM

The potential is truly endless depending on how deep your pockets are..



Series 5 NA (1989 to 1991) produces about 160hp(crank) stock, or about 130whp or so. With a full exhaust, cone filter and a fuel controller like the s-afc unit, you could curve the power to around 145whp maybe 155whp, depending on your tuning.



If you were to pull the motor, and do a large streetport, you should net about another 18% or 26ishwhp. That would land the car right up 170whp to 190whp... stock ecu w/ the above mods (IE: exhaust, s-afc, etc)



Swap over to a standalone like haltch or microtech, you should be able to tune the streetported motor to above 200whp.



Other engine options are bridge, jbridge, or peripheal port. each one offering more and more hp, but will take more and more money and tuning. The more porting, the less engine life.



Say you did swap over the T2..after all the parts are converted, you'd have a stock T2 powerplant, producing anywhere from 150whp to 190whp. You could streetport that motor and go to 220whp or so..



I can go on and on about combinations, but it just depends on how much you want to spend.



I don't personally know any good builders in NJ, but I know KDR in PA is good: http://www.kdrotary.com/



Also check out the dyno section of this forum to see what kind of power others are making w/ what mods...


All times are GMT -5. The time now is 11:33 AM.


© 2024 MH Sub I, LLC dba Internet Brands