ok, I'm done ripping my car apart for day one, wanted to make sure i could get everything done, so far it's all going pretty smoothly, but i do have a few questions for those who have done the install... first off, what is the order in which to hook the injectors up, I have no clue which injector is 1,2,3, or 4, and no clue on which plug to use on which injector... this is the biggest problem I have ran into.... Next question is on using the BAC valve... the manual doesn't tell you how to wire the BAC valve in, tells me how to set it up software side, but not wire it in... I bought the fully terminated harness BTW... and lastly, I didn't really look into this today, but where is the boost control module... I bought the haltech one, after it was ordered I was advised that it isn't that great, but i spent 80 dollars on it, and unless anyone really advises me not to use it and can let me know why not, then I

may as well put it in, was kinda curious on where it goes...everything else seems relatively simple... and also, if anyone has a base load for a TII that I could use to get my car running I'd appreciate it...

ok, I figured everything out except for the BAC valve... I still need to know how to hook that up, and hitman's site doesn't have anything on it....

Don't worry about the bac, Get your car started and adjust the idle with the throttle plate stop screw.





But is you need to know. YOu have to use one of the pwr cables. THe haltech manual will tell you for BAC, don't follow the directions for the stepped motors which is something totally different.



C